Gecko [ fernandoquevedodop.com ]

Name	Size	Permission	Action
config.xdvi	1.46 KB	-rw-r--r--

Code Editor : config.xdvi

% original config.xdvi -- Configuration file for Type 1 rendering in xdvi.
% (If you change or delete `original' in the first line of this file,
% new xdvik installations won't overwrite the file.)
%
% This file is part of xdvik (notwithstanding its location).
%
% Lines starting with `%' are comments.
%
% This file indicates which map files are to be used when running xdvi.
% (It is not used by dvips, unless you type "dvips -Pxdvi ...", which is not
% likely.  Doing so, however, would allow you to use the same map files
% in dvips as are used in xdvi.)
%
% The format is the same as for dvips configuration files, except that only
% the `p' and `p+' directives are used.  A line
%
%	p file.map
%
% clears the existing list of map files and sets the list to the given file.
% A line
%
%	p+ file2.map
%
% adds the given map file to the end of the list.  If you use "p file.map"
% anywhere other than as the first (non-comment, non-blank) line of the file,
% then you are probably making a mistake.
%
% If a font entry is found in several files, the earlier entry will be used
% (as is done in dvips).  Therefore, to override font entries in the standard
% file psfonts.map, you should use entries such as:
%
%	p myfile.map
%	p+ anotherfile.map
%	p+ psfonts.map
%
% However, normally it isn't necessary to add any other map file here
% because psfonts.map is (normally) a generated file (by the updmap
% script).  Instead, map files should be added to the updmap.cfg file.
%
% p psfonts.map

${this.title}

Code Editor : config.xdvi